SOLVOXY (U1); SSPL/EPOXY-MIO-MB (U1)

Two component, high build, self-priming, rust encapsulating, epoxy coating.

Features Technical Data Directions for Use Special Instructions Storage & Packing Safety Information Disclaimer

Features

High performance, epoxy high build coating for protection of steel in aggressive conditions. Self-priming coating, tolerant to lower grades of steel preparation. Compatible with various aged, sound, oleo resinous, epoxy and polyurethane coatings and hence particularly well suited as a maintenance coating. Can be over coated with alkyd, chlorinated rubber, vinyl, epoxy, polyurethane and acrylic dispersion coatings. Suitable for touching up of weld seams and damages to epoxy during construction. Excellent corrosion resistance. Good chemical resistance.

Technical Data

Directions for Use

Surface preparation and Substrate condition.

For Immersion Condition

Steel, blast cleaned to ISO Sa 2.5

Steel with approved shop primer, sweep blasted to SPSS-Ss or power tool cleaned to SPSS-Pt 3.

Existing sound epoxy coating  sufficiently roughened and free from any contamination.

For atmosphere exposure condition

New hot–rolled steel: Blast cleaned to min ISO Sa 2.

Weathered Steel: Power tool cleaned to ISO St 3 or hand tool cleaned to ISO St 2.

Existing sound epoxy coating system and most sound alkyd coating system: sufficiently roughened, dried and cleaned. High pressure water cleaning or water washing and scrubbing remove loose paint and contamination. Intact areas to be roughened. Damaged and rusty areas to be deducted to min. ISO ST 2 by hand tool cleaning.

Mixing

Stir the base and hardener separately. If settling is observed in the base or hardener, loosen the settled material with the help of hand stirrer followed by power driven stirrer for quick homogenous mixing.

Then combine and mix as follows:

Mixing Ratio (by volume) Base: Hardener (1:1) Induction time None Pot life at 300C 8 hours Application-Airless Spray Recommended Thinner SOLVO-THIN Volume of Thinner 0-10% Nozzle orifice 0.48-0.53 mm Nozzle Pressure Brush/Roller 15 mpa (approx. 150 atm, 2100 p.s.i.) Recommended Thinner SOLVO-THIN Volume of Thinner 0-5%

Special Instructions

Applications of two coats of this product is mandatory. Two coat application elevates the performance of the product considerably.

Limitations

Product is not recommended for immersion service in acids, alkalies or solvents.

Storage & Packing

Storage: Store in a cool dry place. Store in accordance with local regulations.

Packing: 20 ltrs.

Safety Information

As a general safety measure, inhalation of solvent vapours or paint mist and contact of liquid paint with skin & eyes should be avoided. Forced ventilation should be provided when applying paint in confined places or stagnant air. Even when ventilation is provided, respiratory, skin and eye protection are recommended when spraying paint.

Please refer our Material Safety Data Sheet prior to using the product.

Disclaimer

To the best of our knowledge the information provided herein are true and accurate at the date of issuance. Since we have no control over quality or condition of the substrate or the various factors affecting the use of any application of the product, we do not accept any responsibility or liability arising out of use of the product.

The company reserves the right to modify data contained herein without prior notice. Any change in data would normally be followed by issue of a new data sheet. The user should check with the nearest sales office to the company and confirm the validity of the information, prior to using the product.